Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1240 AP debug commands

Does anybody know if there is a Debug command on the wireless 1240 IOS AP that will basically show what you get with the "show dot11 associations-all"? I'm looking mostly at the client MAC and the Signal strength/SNR values. Thanks

1 REPLY
Bronze

Re: 1240 AP debug commands

Yes, There is a show command in these APs to show the client. The command reference document in cisco.com will help you to do that

190
Views
0
Helpful
1
Replies