Hi , i checked the configurationa and you have configured the one ssid to work with wpa version one and the other ssid to work with wpa version 2 which is okay, but under the radio you have onky configured to use the ciper of tkip which is for wpa version 1
If you would like to work with The setup you have you should create vlans and link each vlan with the corresponding ssid and specific encryption method, if you have 2 ssids configured and not workin with lans you will have to use the same encryption method on oth ssids.
The errors that you report are see when you have configured the unit incorrectley client issues or rf interfirence.
Also if you try to configure the ap via the gui it will give you an error that you need to use to different encryption ethods on each ssid.
If you access the AP via the GUi, click on security, then SSID manager and then on the ? on the left side you will be able to check on this information.
WPA Pre-shared Key
To support client devices using static WEP keys and WPA key management, you must configure a pre-shared key on the access point. Enter the key and choose the appropriate radio button to specify if you are entering hexadecimal or ASCII characters.
If you use hexadecimal, you must enter 64 hexadecimal character to complete the 256-bit key. If you use ASCII, you must enter a minimum of 8 letters, numbers, or symbols, and the access point expands the key for you. You can enter a maximum of 63 ASCII characters.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...