Hi, I've got a 1242AG LAP that's registered to a 4400 Controller. Problem is, it won't boot properly. When I plug into the console port, I see the following:
The system is not configured to boot automatically. The
following command will finish loading the operating system
After issuing the boot command, the LAP runs just fine. I saw on another post a suggestion to ensure conf reg to 0xF, but nowhere either in the limited CLI on the LAP nor on the controller can I find where this is possible to set.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...