Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1242 and 1220 AP ---can telnet but not web browse?

Hello ,

At my workplace we have recently updated TACACS configuration---just a new key .....and also password of last resort ---this should have gone smoothly--but some APs did not take the config for some reason----therefore myself and other employees had to visit each device and console in to update ---the majority of these worked , but a few will now not allow web browsing ---but you can telnet ---when I examined the config and software --the only difference I could see was the Boot loader was higher on the ones that cant be accessed via HTTP (12.4 (7) JA) if memory serves----whereas the AP's that work correctly have the same version 12.3(7) as the image file ( 12.3) .

Could this be the only reason ? I have checked every line of the config ,and show version---anyone else had a similar problem? Thanks in advance.

  • Other Wireless - Mobility Subjects
3 REPLIES
New Member

Re: 1242 and 1220 AP ---can telnet but not web browse?

Just to specify----I cant web browse as I am refused access , I get the username /password prompt when typing in the IP address---I have a telnet session already open and am using the password of last resort (which I know is correct ) or my TACACS username and password........thanks!

Hall of Fame Super Gold

Re: 1242 and 1220 AP ---can telnet but not web browse?

Is HTTP/HTTPS enabled in the config?

New Member

Re: 1242 and 1220 AP ---can telnet but not web browse?

I will have to check --thanks for replying , I will update later today

722
Views
0
Helpful
3
Replies
This widget could not be displayed.