I recently deployed a 1242a\b\g AP. I can see it in WCS (version 4.1). However, the radio's are stuck in a oper down status. At first I was getting an error that the power was insufficient. It is set up with an ethernet power injector. I switched out the power brick and injector. Now I just get the down status on WCS.
The radios show they are enabled and admin status is enabled, but so far every attempt to bring the radios up has failed. Is there something else I need to check or configure?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...