Whilst working on a 1242AG access point I accidentally deleted the username. The default username had already been deleted when it was first installed.
The config was then saved as the startup config.
Normally I would reset the unit holding the mode button whilst powering up etc and start again. However, this AP is up in the roof of a bus depot and I will need to get access equipment in order to reach it.
It is still on the network for web access but now won't accept any usernames or passwords.
Is there any way round this without having to get physical access to the unit.....?
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...