I want to know if it is possible to connect 3 x 1242G's (non-bridge) to one 1242G (bridge)? The Root-Bridge (Main AP, connected to our LAN with the router) has an omni-directional antenna, the 3 other 1242G's will connect to this one with directional antenna's. There will be no clients clients connecting to any AP's, these are purely used to extend our network because cabling is not an option.
I have tried this setup in the lab and can not get the AP's talking, even with no security and only using the SSID.
Reading on the site I have noted that the "point to multi-point" configurations always refer to the 1242AG AP's and not the 1242G AP's.
Your confirmation and guidance, either way, will be greatly appreciated.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...