Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1250 AP - 40mhz channel selection issue

Every time I try to enable the 40mhz channel bonding for the 5ghz radio I receive the following error message, "slot is not disabled or customize is not enabled". This occurs from both the web and CLI interface.

Thanks.

Steve

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: 1250 AP - 40mhz channel selection issue

You need to set the power and the channel before you can enable the 40mhz channel width.

Use one of these for above 40mhz:

36,44,52,60,100,108,116,132,149,157

Use one of these for below 40mhz:

40,48,56,64,104,112,136,153,161

-Scott
*** Please rate helpful posts ***
3 REPLIES
Hall of Fame Super Silver

Re: 1250 AP - 40mhz channel selection issue

You need to set the power and the channel before you can enable the 40mhz channel width.

Use one of these for above 40mhz:

36,44,52,60,100,108,116,132,149,157

Use one of these for below 40mhz:

40,48,56,64,104,112,136,153,161

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

Re: 1250 AP - 40mhz channel selection issue

New Member

Re: 1250 AP - 40mhz channel selection issue

That worked great. Thanks for your help!

Steve

852
Views
0
Helpful
3
Replies