Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1250 AP with media converter ?

Have any of you tested the LWAPP 1250 AP with a media converter or combination media converter/PoE injector. - Just wondering if there are any that work OK. I don't need 56 volt PoE since I will only have one radio module installed, but I can't see buying a switch for each of these devices and mesh is not good for my application.

Please advise model numbers, etc if you have tested this.

Thanks

Randy

2 REPLIES
Hall of Fame Super Gold

Re: 1250 AP with media converter ?

56 volts PoE for a 1250?? The Autonomous 1250 requires 18.5 watts if both radios are to work.

If you want to use media converter+power injector it would look like this ... switch -> m/c -> power injector -> 1250 AP.

If you are going to use a media converter, you need a power injector regardless if you are going to use one or both radio modules.

New Member

Re: 1250 AP with media converter ?

Take a look at the side of your 1250 AP, it says +56v dc.

I did say I was NOT using 2 radios, and I am presently running 1250 APs with a single "A" radio. You can buy media converters with PoE built in to the converter, so there would be no extra component to buy. I only wanted to know if anyone has tested these things.

regards,

Randy

127
Views
0
Helpful
2
Replies