Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1250 APs have turned their radios off.

We upgraded our controler to ver 5 to cure an issue where the 1250 APs would not turn their radios on. The upgrade seemed to cure that issue but it looks to have come back. Has anyone seen this situation before. I am going to look at this in our lab tomorrow.

3 REPLIES
Hall of Fame Super Silver

Re: 1250 APs have turned their radios off.

What version were you running prior to 5. I have a bunch of installs using the 1252 and the 4.2 code with no issues at all.

-Scott
*** Please rate helpful posts ***
New Member

Re: 1250 APs have turned their radios off.

I believe they were on 4.1.x and needed to upgrade to get around another issue. I have other WISMs on later versions of 4.2 and they are ok. This sites manager decided to upgrade to 5.0.X.

Hall of Fame Super Silver

Re: 1250 APs have turned their radios off.

1252's require the 4.2 code or higher. Also the 1252's require more power than 15.4W. You can supply full 20W with any E-Series switches with a certain firmware. If connected to a 6509, there are other requirements needed to supply 16.8W. If you have a power injector or power cord, then you should be fine. Also make sure no one is pushing out a template in WCS that shuts off the radios.

-Scott
*** Please rate helpful posts ***
129
Views
5
Helpful
3
Replies