Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1250 patched into 6500 CatOS switches

Guys does anyone know of any issues with the 1250 access point being patched into 6500 CatOS switches

When patching the the 1250's in, I noticed that it was showing a 'NotConnect' state.

I then disabled, enabled it, and it came back, and after a certain time they become disconnected.

I tried this against a couple of ports that didn't come up OK, and they did exactly the same thing.

Is there some sort of known problem with these APs and Cat switches running CatOS? There are no errors clocked against the ports…

Please see attached details

Many Thanks,

5 REPLIES
Hall of Fame Super Silver

Re: 1250 patched into 6500 CatOS switches

Here are the requirements for 1250's on the 6500 and some other notes... CatOS isn't supported.

Linecards:

WS-X6148A-GE-45AF

WS-X6148-GE-45AF

WS-X6548-GE-45AF

PoE daughter cards:

WS-F6K-48-AF=

WS-F6K-GE48-AF=

Software Release:

12.2(33)SXH2

March 31

Notes:

Supports 2 radio 11n mode

Recommend 1:1 replacement of 802.11a/b/g to 802.11n

No limitations on the number of AP1250s that can be used with a card or chassis

Chassis power supply must be correctly sized for PoE load

-Scott
*** Please rate helpful posts ***
New Member

Re: 1250 patched into 6500 CatOS switches

Thanks fella,

Does it matter that I am using Power Injectors?

Hall of Fame Super Silver

Re: 1250 patched into 6500 CatOS switches

It shouldn't matter.... If you are using the correct power injectors, then the 1252 should power up fine.

-Scott
*** Please rate helpful posts ***
New Member

Re: 1250 patched into 6500 CatOS switches

The problem I have is that we have 1250 APs that are powered by air-pwrinj4, the power injectors are patched into the Cat switch and are showing as not connected, are we still saying the 1250 are not supported on Cat switches.

I have patched the same AP and Pwr inj into a 3750 and the AP shows connected and is stable.

does this point to your initial comment that the 1250's are not supported on Cat switches

Many Thanks

Hall of Fame Super Silver

Re: 1250 patched into 6500 CatOS switches

Is the port negotiating correctly? The CatOS isn't supported to power up the 1252. I don't see why it wouldn't work if you have a power injector. Do you have an AC plug to power the 1252.... just to see if it can be the injector and the switch not negotiating?

-Scott
*** Please rate helpful posts ***
130
Views
0
Helpful
5
Replies
CreatePlease login to create content