Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1252 LAP.

I Have a 1252 LAP that immediately gives me 3 solid red lights on the top when I give it power.  Is this a dead board.  I cant find info on the 3 red lights anywhere.  I called Cisco but it is out of warranty and they would not even tell me what the 3 red lights mean.

Thanks,

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 1252 LAP.

Its dead.. we normaly replace the device if its under warranty or associated with any contract...

Regards

Surendra

7 REPLIES
Hall of Fame Super Gold

Re: 1252 LAP.

3 red lights?  Sounds like it's dead.  Can you try to remove the radio modules and see if you get the same result?  Have you tried to console into the AP and find out what is the output?

New Member

Re: 1252 LAP.

Yes I have tried all the above.  I see nothing when I console it, and have tried radios from other ap's. Also tried no radios.

It has to be dead, but I was just curious because I see nothing on 3 red light anyware in the forums.

Thanks,

Cisco Employee

Re: 1252 LAP.

Hi Leo / Aritac..

if Ethernet / Radio / Status LED are RED then it means.. the AP is facing some Boot loader errors and its the issue with the DRAM Memory test failure experienced by the AP.

let me know if the above answered your question..

Regards

Surendra

New Member

Re: 1252 LAP.

So can I fix it? Or is it dead?

Cisco Employee

Re: 1252 LAP.

Its dead.. we normaly replace the device if its under warranty or associated with any contract...

Regards

Surendra

New Member

Re: 1252 LAP.

Thank you so much for the info.

Love the Cisco Forums......

Cisco Employee

Re: 1252 LAP.

its our pleasure to help you.. Thank you for using the support forum!!

Regards

Surendra

4870
Views
0
Helpful
7
Replies
CreatePlease login to create content