Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

1300 bridge question

I have a set of bridges working right now on 1 vlan..which is the mgmt vlan I believe. What I need to do is add 4 more vlans plus a management vlan to this link for student registration(reg,quarentene,no -access and fullaccess vlans). The SSID I have now between the bridges is Wep'd..so do I need to individually add these's Vlans as well and wep them too? I'm kind of confused after reading the doc on the bridges they only use 1 vlan which isn't much help.

Also, both sides need to have the same Vlans configured right(local and remote)?

Thanks for any help,

Jeff

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: 1300 bridge question

You extend VLANs into a wireless LAN by adding IEEE 802.11Q tag awareness to the access point/bridge. VLAN 802.1Q trunking is supported between root and non-root access point/bridges through the access point/bridges' primary SSID.

try this link:

http://www.cisco.com/en/US/docs/wireless/access_point/1300/12.2_15_JA/configuration/guide/o13vlan.html

1 REPLY
New Member

Re: 1300 bridge question

You extend VLANs into a wireless LAN by adding IEEE 802.11Q tag awareness to the access point/bridge. VLAN 802.1Q trunking is supported between root and non-root access point/bridges through the access point/bridges' primary SSID.

try this link:

http://www.cisco.com/en/US/docs/wireless/access_point/1300/12.2_15_JA/configuration/guide/o13vlan.html

105
Views
4
Helpful
1
Replies
CreatePlease to create content