I have two 1300s that I am trying to set up as Root Bridge and Non-Root Bridge, however, everytime i specify one of them as a Non-Root bridge, the radio0 interface becomes disabled. The only option that i am able to pick that enables the radio0 interface is "Access Point", which is what am trying to avoid it being.
Can anybody help me figure out how to go about this
A non-root's radio will show as disabled if it cannot find the root AP to associate to. Make sure you have "infrastructure-ssid" configured under the SSID on both the root and non-root bridges. Also depending on code versions you may have to configure the distance command under the radio interface on the root.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...