Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1310 - problems with multipoint network.

Hi,

I have of the problems with one developed network wifi on three points. I have developed the network with a point of access used in modality "repeater", a mobile point in modality "workgroup-bridge", a fixed point in modality "root AP-ONLY". The mobile point is a ship that enters in the port in determines moments to you of the day. All it seems to work BUT when the ship enters in the port, the repeater becomes unstable. The link associations pass in state down, the interface radio of repeater goes in modality reset. In the log is evidenced only the fall of link. What could cause this instability? I accept whichever council.

Thanks

Antonino

  • Other Wireless - Mobility Subjects
1 REPLY
Silver

Re: 1310 - problems with multipoint network.

Attacks that use ICMP "hard" error messages Attacks that use ICMP "fragmentation needed and Don't Fragment (DF) bit set" messages, also known as Path Maximum Transmission Unit Discovery (PMTUD) attacks

Attacks that use ICMP "source quench" messages

Successful attacks may cause connection resets or reduction of throughput in existing connections, depending on the attack type

96
Views
0
Helpful
1
Replies
This widget could not be displayed.