Do you have these bridges close to each other? You might be over powering the bridges. What rssi and data rate are the bridges connecting at. I also noticed that the non root had the antenna receive set at the left side. It is hard to test bridges indoor unless you can separate them apart distance wise. With bridges close together, you will need to lower the power down a lot. If you are seeing errors or bad rssi or data rates, it's because the bridges are too close to each other.
That depends... You can use a power calculator or what else you can do is setup the bridges at mac and then when the bridges connect, you can look at the stats and lower the power little by little until the signal starts to degrade or the link is lost. Then you will know the minimum tx power level.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...