Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1310 with AIR-ANT24120 has a weak Signal

I have two building 150 meters away;

one 1310 + air-ant24120

one 1310 internal patch antenna

I cannot align antennas even;

they are directly see each other

they are 150 meters avay

I am not sure "antenna gain" parameters

here is the config of (1310 + air-ant24120)

interface Dot11Radio0

no ip address

no ip route-cache


encryption key 1 size 128bit 7 xxx transmit-key

encryption mode ciphers aes-ccm tkip wep128


broadcast-key change 1800 membership-termination capability-change



ssid xxx


antenna transmit right

antenna receive right

antenna gain 28

channel 2427

station-role root bridge

bridge-group 1

bridge-group 1 spanning-disabled

service-policy output ATA-SES


Hall of Fame Super Silver

Re: 1310 with AIR-ANT24120 has a weak Signal

All I can say is make sure the antenna connections are on tight. Also, what is the cable length from the antenna to the 1310 and what type of cable?

*** Please rate helpful posts ***
New Member

Re: 1310 with AIR-ANT24120 has a weak Signal

antenna gain 28

is it true? for 12dbi omni antenna?