Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1410 bridge stacks between 2 buiding

i am designing a bridging solution that requires loadsharing and redundancy with 2 antenna on two building with 1410 bridge to have more bandwith. Looking at the 1410 deployment guide without ethernetchannel

1 REPLY
Silver

Re: 1410 bridge stacks between 2 buiding

Using PaGP on the switch protocol would be useful. But PaGP protocol limits the failover capabilities.Make sure channels are not overlapping between brdiges in the same sight.

101
Views
0
Helpful
1
Replies