I have two 1410 bridges, one configured as root and the other as non-root. I upgraded the root bridge and lost communication with the non-root. I tried to upgrade the non-root and I get a polling window that pops up and gives the status as IDLE restart complete. It will not upgrade. Any ideas?
Load the recovery image 12.3.7JA or higher into the bridge. Use the command bridge#dot11 dot11Radio 0 recovery-fw flash:c1410-k9w7-mx.123-7.JA/6501.img to use the recovery image. Now upgrade the required image.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...