Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

1500 Mesh over WAN

I know that for lightweight APs to work across a WAN they have to be setup for REAP mode. Will 1500series mesh radios work over a WAN?

2 REPLIES

Re: 1500 Mesh over WAN

1500 does not support REAP or H-REAP modes. If you want to deploy 1500 over a WAN, the link must have enough capacity to pass all of your user traffic, lwapp control traffic, and have a latency less than 100ms between controller and AP.

HTH,

Rich

New Member

Re: 1500 Mesh over WAN

Keep in mind that REAP or HREAP is only required if the clients connecting to the AP require access to data that resides at the site where the AP's ethernet link is terminated. If this site has no direct internet access and all applications reside in a data center where the controller is deployed, there is no need to run REAP or HREAP mode. Richs' statement of the bandwidth and latency requirements still hold true either way.

181
Views
0
Helpful
2
Replies
CreatePlease to create content