2 AP 350 connected to a Catalyst 2950 at the same VLAN...
I have two AP 350 connected to a Catalyst 2950 at VLAN 3.
This is the problem... if one user is working with his notebook (connected to AP 1) and starts walking to the other office so AP 2 would have to take control of the connection... how does Catalyst stop sending traffic to port fa 0/1 and starts sending traffic to port 0/2 where the AP 2 is connected???
Do I do myself clear???
I think it could be a good idea to set the mac address-table aging-time to 0 for VLAN 3. So VLAN would start working as a hub, sending traffic to all its ports.
But in practice this could not be done.
I am working with two AP 350, Catalyst 2950 and IOS 12.1(13)EA1
Re: 2 AP 350 connected to a Catalyst 2950 at the same VLAN...
I don't know where it's documented (nor did I look), but my understanding is that when a client associates to a Cisco AP, the AP will generate a broadcast using the client MAC address, thus populating MAC forwarding tables in the switches.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...