Do you know if the new 2500 series controller supports things like mobility groups? Could I use 2 of these and do inter-controller roaming.
Also do you know if this would work with a 2106 controller and a 2505 controller or are they 2 completely independent controllers only knowing about their own APs??
Here is the link that tells us the features htat are not supported on 2500!! rest all things are supported!!
Please dont forget to rate the post if thids answered ur question!!
To answer your questions more specifically -- yes, the 2500 WLC supports mobility groups, and you can have mobility groups combined with the various controller platforms (2100,2500,4400,5500).
just have to change parnter to customer.
no mobility and roaming is not the same. You need for roaming between controllers a mobility configuration.
If you have only one 2500 WLC and 25 or more or less AP roaming between the AP on the one WLC will work well.
This calls Intra-Controller roaming
If you have 2 or more WLCs you need a proper mobility config for roaming between APs located on differen WLC.
This Calls Inter-Controller roaming.
More informations are here:
Thank you for fast reply.
I will check the guide.
One more question please. Wireless Control System is not needed for roaming and Voice over WLAN?
WCS is for multiple WLC and some advanced features?
No, WCS is only a management software. It doesn't have any impact for roaming or else. Only for configuration.
Meantime it is replaced by NCS Prime.
You are welcome ;-)
Can you please rate the post if Paul has answered your question. This helps out knowing what has been answered.
Sent from Cisco Technical Support iPhone App