Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

2504 WebAuth and IPv6 RADIUS Accounting (IPv6-Framed-Address)

Hi Board,

I'm playing around with RADIUS Accounting in combination with local web authentication on the wireless LAN controller.

So far so good - everything works well, but I'm missing the "IPv6-Framed-Address" in the RADIUS accounting messages.

The only thing I can see is the v4 framed IP address and the "Framed-IPv6-Prefix". According to the configuration guide

http://www.cisco.com/c/en/us/td/docs/wireless/controller/8-0/configuration-guide/b_cg80/b_cg80_chapter_0101001.html#ID807

the "IPv6-Framed-Address" should be sent by the WLC. I took a capture on a span port of the WLC to verify this. Anybody else experiencing this behavior or is it a simple misconfiguration on my side? In the client details I can see the global IPv6 addresses and the link-local.

I tested it on a WLC 2504 with 8.0.100.0 code.

 

Cheers

Johannes

 

 

1 REPLY
Cisco Employee

Late reply, but hopefully of

Late reply, but hopefully of use. You'd need the following config to send both attributes:

 

config wlan radius_server acct framed-ipv6 both {wlan number}

 

 

206
Views
5
Helpful
1
Replies
CreatePlease login to create content