I followed the instruction to flash the formware via the console. I erased the Flash but was unable to upload the image. Now, each time I connect via the Console port, the Express Setup is no longer there. All I see is the main menu.
I could see 2 fiels: a) Config:AP Installation Key b) Config:AWC_ConfigDB
I tried uploading these file into Flash but it take forever(tried overnight) but never succeed.
Before I send in the AP for repair, is there anything I should try.
I just had the same issue as a previous post inregards to a firmware upgrade going south on a BR-342. The flash haulted in the middle now I can not access through the console at all. Is there a boot strap inside the box that can be reset for default access?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...