I upgraded my 350 series Wireless Bridges to 12.03T, one of them is working fine, the other says:
**PCMCIA Card in Socket 0 is not recognized
**Failed to load driver for device entry #2
when it boots up and the wireless interface is not showing up under Network ports or the setup page. Also in the bottom left area it says "Cisco BR340 12.03T" instead of "Cisco 350 Series 12.03T" like my other one. unfortunately I dont have a service contract on it, so I am hoping it is easy to troubleshoot.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...