Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

350 bridge with clients and other bridges

Q1) Is it possible to use a 350 Bridge in root mode and have clients as well as other 350 Bridge (non-root w/o clients) associate to it?

Q2) Will a non-root bridge roam seemlessly between two root bridges that are widely separated?

Thanks

Henry

1 REPLY
Cisco Employee

Re: 350 bridge with clients and other bridges

A1: you can use 350 in root mode and have client and rot both associae to it

A2 : if you planning to install root bridges and have not root bridges in motion so that it can roam between all root bridges , yes it works fine .

http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo_350/350brdgs/brscg/br350ch3.htm#1016921

I hope this helps

92
Views
0
Helpful
1
Replies