Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

350 Eth Bridge talking to 340 Workgroup Bridge?

we have a centrally located 350 ethernet bridge that I am trying to connect to from a 340 eorkgroup bridge.

The association is happening and also the WEP but I cannot ping past each unit. I can ping from one unit to the other but not to a device on their local LAN.

I thought there was an issue with STP but not sure.

In another scenario we have a 340 EBridge with 350 WBridge which talk fine.

Thanks, Ian.

1 REPLY

Re: 350 Eth Bridge talking to 340 Workgroup Bridge?

Often times complex troubleshooting issues are best addressed in an interactive trouble-shooting session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

129
Views
0
Helpful
1
Replies