Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

350 Series Client card associates but unassigned IP Address

I have loaded a 350 Series Client card into a HP Vectra PC. I previously had Version 4.13 software loaded on the PC with the old firmward for the Wireless Card.

I updated the software on the PC to Version 5.05 as well as the firmware on the card. The PC is able to associate to the Access Point BUT I am seeing an "UNASSIGNED" message on the Access Point under the associations tab.

Did I get myself into a pickle by undating the software version from V4.13 to V5.05? Or could it be the firmware version that is causing this not to work? I need help.

  • Other Wireless - Mobility Subjects
1 REPLY
Cisco Employee

Re: 350 Series Client card associates but unassigned IP Address

Did you also update the NDIS driver ?

There are 3 parts of the software and ALL 3 should be of the same age/release

Firmware NDIS and ACU.

I recommend that you download the latest bundle and update all 3 parts of the software, if you still have this issethen it sounds like a WEP key mismatch, reconfigure both the AP and the client cards WEP key making sure you use the same key entry method ie. HEX

106
Views
0
Helpful
1
Replies
This widget could not be displayed.