Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3502i Access Point in autonomous mode? "... same bridge group is not permitted"

We are replacing three autonomous AIR-LAP1131AG-A-K9 with three autonomous AIR-SAP3502I-A-K9. The 1131s have 12.4 and the 3502is have 15.2. We tried copying the 1131 config onto the 3502Is but we get a message which states, "Configuration of subinterfaces and main interface
within the same bridge group is not permitted"

 

Anyone able to help us with this? Below is more of the config/error messages we are getting when copying the 1130 config onto our 3502;

 

 

 

 

Enter configuration commands, one per line.  End with CNTL/Z.
USA-NYC3502i-01(config)#interface Dot11Radio0.960
USA-NYC3502i-01(config-subif)# encapsulation dot1Q 960
USA-NYC3502i-01(config-subif)# no ip route-cache
USA-NYC3502i-01(config-subif)# bridge-group 1

Configuration of subinterfaces and main interface
within the same bridge group is not permitted
USA-NYC3502i-01(config-subif)# bridge-group 1 subscriber-loop-control
STP: Unable to get the port parameters.
USA-NYC3502i-01(config-subif)# bridge-group 1 block-unknown-source
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# no bridge-group 1 source-learning
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# no bridge-group 1 unicast-flooding
Please confi
*Mar  1 02:30:51.584: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to down
*Mar  1 02:30:51.591: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to resetgure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# bridge-group 1 spanning-disabled
*Mar  1 02:30:51.647: Invalid spanning tree index
*Mar  1 02:30:52.585: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to down
*Mar  1 02:30:52.607: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to up
*Mar  1 02:30:53.607: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to up
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#interface Dot11Radio0.960
USA-NYC3502i-01(config-subif)# encapsulation dot1Q 960
USA-NYC3502i-01(config-subif)# no ip route-cache
USA-NYC3502i-01(config-subif)# bridge-group 1

Configuration of subinterfaces and main interface
within the same bridge group is not permitted
USA-NYC3502i-01(config-subif)# bridge-group 1 subscriber-loop-control
STP: Unable to get the port parameters.
USA-NYC3502i-01(config-subif)# bridge-group 1 block-unknown-source
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# no bridge-group 1 source-learning
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# no bridge-group 1 unicast-flooding
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# bridge-group 1 spanning-disabled
*Mar  1 02:31:05.359: Invalid spanning tree index
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#interface Dot11Radio0
USA-NYC3502i-01(config-if)# no ip address
USA-NYC3502i-01(config-if)# no ip route-cache
USA-NYC3502i-01(config-if)# !
USA-NYC3502i-01(config-if)# encryption vlan 960 mode ciphers aes-ccm tkip
USA-NYC3502i-01(config-if)# !
USA-NYC3502i-01(config-if)# ssid NEEfroOff
USA-NYC3502i-01(config-if)# !
USA-NYC3502i-01(config-if)#$ic-5.5 basic-11.0 basic-6.0 basic-9.0 basic-12.0
*Mar  1 02:31:47.522: %LINK-6-UPDOWN: Interface Dot11Radio0, changed basic-24.0 basic-36.0 basic-48.0 basic-54.0      
USA-NYC3502i-01(config-if)# station-role root
USA-NYC3502i-01(config-if)# bridge-group 1
USA-NYC3502i-01(config-if)# bridge-group 1 block-unknown-source
USA-NYC3502i-01(config-if)# no bridge-group 1 source-learning
USA-NYC3502i-01(config-if)# no bridge-group 1 unicast-flooding
USA-NYC3502i-01(config-if)# bridge-group 1 spanning-disabled
USA-NYC3502i-01(config-if)#!
USA-NYC3502i-01(config-if)#interface Dot11Radio
*Mar  1 02:31:47.528: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset
*Mar  1 02:31:48.522: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to down
*Mar  1 020.960
USA-NYC3502i-01(config-subif)# encapsulation dot1Q 960
USA-NYC3502i-01(config-subif)# no ip route-cache
USA-NYC3502i-01(config-subif)# bridge-group 1

Configuration of subinterfaces and main interface
within the same bridge group is not permitted
USA-NYC3502i-01(config-subif)# bridge-group 1 subscriber-loop-control
STP: Unable to get the port parameters.
USA-NYC3502i-01(config-subif)# bridge-group 1 block-unknown-source
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif:31:48.544: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to up
*Mar  1 02:31:48.940: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to down
*Mar  1 02:31:48.947: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset
*Mar  1 02:31:49.809: Invalid spanning tree index
*Mar  1 02:31:49.963: %LINK-6-UPDOWN: Interface)# no bridge-group 1 source-learning
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# no bridge-group 1 unicast-flooding
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# bridge-group 1 spanning-disabled
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)#! Dot11Radio0, changed state to up
*Mar  1 02:31:49.969: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to down
*Mar  1 02:31:49.975: %LINK-5-CHANGED: Interface Dot11Radio0, changed state to reset
*Mar  1 02:31:50.991: %LINK-6-UPDOWN: Interface Dot11Radio0, changed state to up
*Mar  1 02:31:51.992: %LINEPROTO-5-UPDOWN: Line protocol on Interface Dot11Radio0, changed state to up
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#interface Dot11Radio0.960
USA-NYC3502i-01(config-subif)#no shut
USA-NYC3502i-01(config-subif)#encapsulation dot1Q 960
USA-NYC3502i-01(config-subif)# no ip route-cache
USA-NYC3502i-01(config-subif)# bridge-group 1

Configuration of subinterfaces and main interface
within the same bridge group is not permitted
USA-NYC3502i-01(config-subif)# bridge-group 1 subscriber-loop-control
STP: Unable to get the port parameters.
USA-NYC3502i-01(config-subif)# bridge-group 1 block-unknown-source
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# no bridge-group 1 source-learning
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# no bridge-group 1 unicast-flooding
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)# bridge-group 1 spanning-disabled
*Mar  1 02:32:07.670: Invalid spanning tree index
Please configure the bridge group on this interface first.
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#
USA-NYC3502i-01(config-subif)#end
USA-NYC3502i-01#

1 REPLY
Gold

Hi,Could you please share the

Hi,

Could you please share the full default configuration now on 3502i and new configuration which you are planning to put on 3502i?

Regards

Najaf

 

68
Views
0
Helpful
1
Replies