When the page completes loading go to the bottom of the page until you reach the 1130 and the 1140. The 3500 will share the same "signature" as the 1130 and the 1140. Due to the design, the signal distributes closely like a ball and you can mount the 3500i either from the roof or flat from a wall.
Please don't forget to rate our useful posts. Thanks.
The 1130 has a elevation Beamwidth of 50 degrees compared to 120 for the 1140. That is night and day for placement planing. Any ideas on where to find the actual pattern for the 3502 with the built in antennas?
tan 60 X ceiling height = Radius of floor coverage above 3db
tan 25 X ceiling height = Radius of floor coverage above 3db
For a 16 ft ceiling= ~28ft radius for the 1140 vs ~7.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...