Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

3850 as MC and 5508 as Anchor Guest

Can i use a 5508 WLC with relase 7.4.121.0 as anchor guest for a 3850 configured as Mobility Controller?

The Converged access (new mobility) is supported only in 7.3.112 or 7.5 and later relase, but i don't need to configure the 3850 as Mobility Agent.

I need to configure the 3850 to connect to my anchor guest controller 5508 in DMZ.

 

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

HiYou need to run 7.6.110.0

Hi

You need to run 7.6.110.0 on your 5508 & enable "New Mobility" feature on your 5508 if you want to have Anchor-Foreign setup between 3850 & 5508.

 

 NB: 7.3.x & 7.5.x codes are differed & 7.4.x code does not support this "new mobility"

 

HTH

Rasika

**** Pls rate all useful responses *****

2 REPLIES
VIP Purple

HiYou need to run 7.6.110.0

Hi

You need to run 7.6.110.0 on your 5508 & enable "New Mobility" feature on your 5508 if you want to have Anchor-Foreign setup between 3850 & 5508.

 

 NB: 7.3.x & 7.5.x codes are differed & 7.4.x code does not support this "new mobility"

 

HTH

Rasika

**** Pls rate all useful responses *****

Hi Rasika,Do you know if this

Hi Rasika,

Do you know if this works the other way as well? Can you anchor traffic from 5508 to a 3850?

Cheers,

Richard

637
Views
0
Helpful
2
Replies
CreatePlease to create content