Is it Central web-authentication/BYOD or WLan traffic anchored to some other controller ?
In any case I can only bring out one difference , In 3.6 version , stuff like redirection etc on IOS-XE acts similar to what we have been doing IN CUWN i.e 5508 controller. Before that , it is different.
Coming to 3.3.4 , this will require dedicated Tshoot etc , So better to get handled via a TAC case in my opinion.
But as a first step check the o/p of "#sh wireless client mac-address" after the client gets an ip address to see if redirect URL and ACL are returned by the ISE or not.
I mean that the way redirection is done (interaction with the browser) has been improved in 3.6 but as I said for 3.3.4 , you will need to Tshoot properly. Since you are getting Redirect URL and ACL and still you dont get it then you will have to run debugs on the box to see what is happening.
Alternatively , you can also capture the packet on the client for example using wireshark on windows wireless NIC card to see if it is getting that URL etc.
If you are not getting any thing towards client based on the capture , then I think you should open a TAC case to get this investigated.
We figured out that the problem was that the 3850 switch where the Guest User is assigned had no VLAN interface in the same VLAN as the guest client. As we just configured the vlan interface it worked.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...