Hi All, i have 2 4400 Controllers to integrate. Both are connected via LAG, Switchconfig config follows the Deployment Guide. with no dynamic Interface configured, everything works fine. With the first dynamic Interface i configured, my trouble begans. The Mangement Interface is no more reachabel, nor ping or https goes through. With dynamic Interface disabled, everything works fine. I changed to an other chassis, with no Channel Config but with only one Interface and a Trunk, same picture. Any idea? Regards, Michael
Can you please confirm which version of code you are running? Also can you post the output of "sh interface summary" & "sh lag" and also the port config of switchport on which this controller is connected?
Hi Ankur, the 4400 are running 18.104.22.168. For the Moment we have disabled LAG and are using a single Trunk Connection. I had checked this befor, LAG was enabled and from the Switch Side the Etherchannel was established. All necessary VLANS were allowed and one of them (which with the Management and AP-Manager IP) were configured as native VLAN. Thank you for replying, best regards, Michael
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...