Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4402 Controller and Different power levels for different SSIDs

I am using a 4402 controller and want to have different power levels for different SSIDs. For example I want the Guest network SSID to not be visible as far out as I want the production network SSID. Can I do this with the controller and if so where do I set that?

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: 4402 Controller and Different power levels for different SSI

The tx power levels are set on a per radio basis so all WLANs on the same radio will have the same power level.

2 REPLIES
Gold

Re: 4402 Controller and Different power levels for different SSI

The tx power levels are set on a per radio basis so all WLANs on the same radio will have the same power level.

Hall of Fame Super Gold

Re: 4402 Controller and Different power levels for different SSI

"I want the Guest network SSID to not be visible"

Disable Broadcast SSID for your Guest SSID.

If you configure AP Groups, you can allow your specific SSID, such as Guest, not to be broadcasted in specific location (based on AP).

Hope this helps.

264
Views
0
Helpful
2
Replies