Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

4402 controller high LAN utilization(600 Mbps)

Hi everybody,


I'm trying to configure Cisco 4402 series wireless lan controller on a proof of concept lab, but it's generating extremely high LAN utilization (around 600-700 Mbps) on its connected port to backbone switch. We are using GLC-T on 4402's port 0 for local connectivity. This traffic is starting even we do not use any access points in wireless network.


I configured controller 2 times after resetting to factory default, but the result is the same.


Best Regards

Ozan Oguz

CCIE#22559

2 REPLIES
Gold

Re: 4402 controller high LAN utilization(600 Mbps)

This is not an issue I've heard of.  Are you managing the controller with a SNMP device?  I would suggest you start with a sniffer sourcing the ports going to the controller to see what the traffic is and where/to its going.

New Member

Re: 4402 controller high LAN utilization(600 Mbps)

problem has been solved by adding "switchport trunk allowed vlan x,y,z" command to the backbone switch.

OZan

203
Views
0
Helpful
2
Replies