5508 controller version 7.1.91.0 and supported ap (list)

[Giuliano Gerardi]

I need to know for shure if the aps listed below are compatible with 5508 controller version 7.1.91.0

the ap's are

AIR-LAP1242AG-E-K9

AIR-LAP1242G-E-K9

AIR-CAP3501E-E-K9

AIR-CAP3502E-E-K9

AIR-LAP1231G-E-K9 

of course I checked release notes

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn7_1_91_0.html

but for me it is not that clear...

thank you in advance

[thomas03usmcsf]

Yes

Sent from Cisco Technical Support iPhone App

[Leo Laohoo · Accepted solution]

AIR-LAP1231G-E-K9

NO it's not.  The 1230 is last supported on the 7.0.X firmware.  Look under the heading "Software Release Support for Access Points"

[blakekrone · Accepted solution]

AIR-LAP1231G is not supported under the 7.1 or 7.2 codes. Unfortunately if you still have those lying around you may need to designate a controller as "legacy" and run 7.0 code on it to support them.

[Giuliano Gerardi]

thank you everybody so the last column in the compatibility table (last supported) is to be empty or with "--" then the ap is supported while for example if written "7.0" that means it is not in version >7.0 ...Is that right?

Table 1-2     Software Support for Access Points

Access Points		First Support	Last Support
1000 Series	AIR-AP1010	3.0.100.0	4.2.207.0
	AIR-AP1020	3.0.100.0	4.2.207.0
	AIR-AP1030	3.0.100.0	4.2.207.0
	Airespace AS1200	—	4.0
	AIR-LAP1041N	7.0.98.0
	AIR-LAP1042N	7.0.98.0
1100 Series	AIR-LAP1121	4.0.155.0	7.0
	AIR-LAP1131	3.1.59.24	—
	AIR-LAP1141N	5.2.157.0	—
	AIR-LAP1142N	5.2.157.0	—

[Leo Laohoo]

if written "7.0" that means it is not in version >7.0

It means it's supported UP TO version 7.0.X and will not be supported on 7.1.X and higher.

[thomas03usmcsf]

Good catch Leo, I didn't even see that 1231 hanging out down there. Good job.

Sent from Cisco Technical Support iPhone App

[Leo Laohoo]

Thanks Thomas.

[Giuliano Gerardi]

however thank you all for your support!!