Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

5508 HA In Remote Location

Hi,

I am setting up a 5508 HA.  Is there any place I can get an example of the configuration?  I am  confused about the addresses that need to be configured.

Also, can I locate the Primary and the Secondary in two different locations, as long as they are reachable?  I have a colocation that is less then 30ms from the office.  Can the Redundancy ports be routed to eachother?

Thanks,

Scott

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

5508 HA In Remote Location

Can't be routed and should really be located in the same location.

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/7-5/High_Availability_DG.html

-Scott
*** Please rate helpful posts ***
4 REPLIES
Hall of Fame Super Silver

5508 HA In Remote Location

Can't be routed and should really be located in the same location.

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/7-5/High_Availability_DG.html

-Scott
*** Please rate helpful posts ***
Hall of Fame Super Silver

5508 HA In Remote Location

VIP Purple

5508 HA In Remote Location

HI,

I am setting up a 5508 HA.  Is there any place I can get an example of the configuration?  I am  confused about the addresses that need to be configured.

Here is the deployment guide:

http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/7-5/High_Availability_DG.html

Also, can I locate the Primary and the Secondary in two different locations, as long as they are reachable?  I have a colocation that is less then 30ms from the office.  Can the Redundancy ports be routed to eachother?

Yes You can but make sure they are connected with redudent port(Layer 2 connectivity). If your remote brach is in another city or in another country then its not possible.

Check the HA  Question and Answer here:

http://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1130-ag-series/qa_c67-714540.html

Regards

Dont forget to rate helpful posts

Hall of Fame Super Gold

5508 HA In Remote Location

Also, can I locate the Primary and the Secondary in two different locations, as long as they are reachable?

Not possible unless you bridge the VLANs.   The redundancy ports of the 5508 has to be physcially connected.

130
Views
15
Helpful
4
Replies
CreatePlease login to create content