I am having an issue with internal and external clients. When we have the nat ip configured on the controller we cannot connect internal ap's at all. When we take the nat ip out it works fine. We are on code 7.0.220. I have tried the following command <config network ap-discovery nat-ip-only disable> and it did nothing. Any ideas?
I know that there was a bug in the 2504 WLC code that matches this scenario, the WLC would always respond with the NAT IP address regardless of the CLI command issued. I wonder if you are hitting a similar deal? I don't have a 5508 available at the moment to test though.
For that scenario it was fixed in 184.108.40.206 which is a special request via TAC.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...