I have a Cisco 5508 on a new installation. We currently have autonomous mode APs through a third party solution.
We have converted two test APs to Lightweight mode using the conversion tool and controller.
We can associate to the APs and see them join the controller. Our SSID is visible and being broadcast.
We can access sites internal to our network (http traffic). We are unable to load external sites.
A new VLAN was created on our core switch in a port channel configuration to the controller.
When we create traffic using a laptop on the same vlan (through a slightly different path.....we can hit the internet, ftp, and telnet with no problem. Switching back to the WLC, telnet and FTP traffic also halt as well. A few bytes pass and then the TCP/IP sessions hang when passing through the controller.
Our next step is to wipe the config back to defaults and start over. I would like to know if anyone has seen an issue with buffer overflows or stops?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...