I'm considering deploying a wireless network between two of my buildings, the issue is that I'm in close proximity to an airport. I seriously doubt that this would be a problem (after al, why would the FCC ratify a standard for buisness use if it was going to rack up plane wrecks). However, due diligience means that I find out for sure. Does anybody know if I should be concerned about the Wireless network effect on planes? (were talking about a major International Airport, nothing small about it..one of the largest in the USA).
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...