I attended a Cisco class that focused on implementing an 802.11b network. In that class we were told that as a rule of thumb the data rate can be tied to Signal/Noise Ratio. With a ratio above 10+dB, you can expect an 11Mbps data rate, 8+db = 5.5 Mbps, 6+dB = 2Mbps and 4+dB = 1 Mbps.
Has anyone ever seen something like this for the 802.11g standad?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...