Cisco Support Community
Community Member

877w Config issues


I am facing some issues while configuring a 877w ADSL wireless router.

1. I have configured 2 SSID in my router. But i think only one SSID is brocasted and seen in the outside world. While checking the configs one of the SSID missed the command guest-mode even after configuring that. After assigning the command once again, i can see the new SSID and the old one was wanished and also cannot see the line guest-mode which i saw earlier.

2. I cannot add encryption key inside interface Dot1radio0. When i add this the following message appears.

Max supported static key sets reached for Dot11Radio0

So, i am waiting for some ones suggestion.

I have attached the configs.

interface Dot11Radio0

no ip address

no ip redirects

ip local-proxy-arp


broadcast-key vlan 1 change 300

broadcast-key vlan 2 change 300



encryption vlan 1 key 1 size 128bit xxxx

encryption vlan 1 mode wep mandatory


encryption vlan 2 key 1 size 128bit xxx transmit-key

encryption vlan 2 mode wep mandatory


encryption mode wep mandatory


ssid East

vlan 1

authentication open


ssid West

vlan 2

authentication open



speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0 54.0

power local cck 20

power local ofdm 17

station-role root

no cdp enable

no shut





Re: 877w Config issues

Segmentation by device types: You can segment your wireless LAN to allow different devices with different security capabilities to join the network. For example, some wireless users might have handheld devices that support only static WEP, and some wireless users might have more sophisticated devices using dynamic WEP. You can group and isolate these devices into separate VLANs.

CreatePlease to create content