I was given an 881 router to work on. I was told that it has the integrated wireless module installed, but I cannot see any radio antenna on the device. Is there a command I can run to determine if the wireless module is installed. I tried sh ver and it did not reveal any information to suggest there is a wireless module.
Also in global configuration mode, the command interface Wlan-ap0, is not accepted.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...