I have 3 1131AG access points that i am setting up in my office building. I would like to setup each ap in such a way that if a user is connected wirelessly that can "roam" throughout the building, and if they get dropped off, once they are in range again to any of the 3 ap's they will connect automatically. What do I need to do in order to make this happen?
You would just need to have the same SSID on each AP. It is your choice as to what security you want to run on the AP and client. Just set the client up with the same SSID and security settings and they will automatically connect and roam.
As for security, the simplest most secure method I can suggest to you would be WPA2-PSK. Use a very strong Pre-Shared key, 10 character, alpha numeric and special character with AES encryption. Unless you have a radius server, then you could set up PEAP.
The only way I can think of setting up notification would be using SNMP traps.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...