Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Access Points 2702i

Hi

Whe have deployed some AP2702i. And I am trying to run traffic on both data ports on the AP.

The POE port is attached to WS-2960S switch and is pulling16,8 Watts, and the AUX port is connected to the same switch and same VLAN. But AUX port is “down” on AP

I have not done any configuration on AP just Default installation. Do I have to config AUX port?

Johan Lindstrand

 

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Hi,AUX port will be disabled

Hi,

AUX port will be disabled if the AP is being powered by a limited 15.4 W .3af PoE source because it requires PoE+, .3at, or local power (wall brick type power supply) to properly function.

 

Regards

1 REPLY
VIP Purple

Hi,AUX port will be disabled

Hi,

AUX port will be disabled if the AP is being powered by a limited 15.4 W .3af PoE source because it requires PoE+, .3at, or local power (wall brick type power supply) to properly function.

 

Regards

166
Views
0
Helpful
1
Replies
CreatePlease to create content