Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Add a FastEthernet interface to mobility group

I admit I don't completely understand mobility groups. I need to add a server on one of the wireless networks. I can't seem to figure out if there is a way to configure a port on a 6509 to be in the same wireless mobility group.

Thanks.

Edited: No need to respond. Just talked to TAC and found out this is not possible at this time.

1 REPLY
New Member

Re: Add a FastEthernet interface to mobility group

i am quite new too. but i don't think you can. mobility group is for wireless part of the network, assigned to tunnel and ssid in the aps only.

110
Views
0
Helpful
1
Replies
CreatePlease to create content