Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Gold

adding an extended IP acl to a 1300 AP

I need to filter by IP addresses the devices passing *through* (not associating with) a 1300 configured just as a point2point bridge. can an extended ACL do this on this device, and if so, do you configure ingress filtering on the bvi or fasteth interface?

I need to filter traffic entering on the wired side, not the wireless side.

TIA

1 REPLY
Bronze

Re: adding an extended IP acl to a 1300 AP

yes, you can configure a IP filter and apply it to the fast ethernet interface, pls. refer to following link for detail configuration:

http://www.cisco.com/en/US/docs/wireless/access_point/1300/12.3_7_JA/configuration/guide/b37filt.html

225
Views
0
Helpful
1
Replies