Has somebody work with adding Autonomous AP to TACACS. I can access the cli mode after I added the same; but I am facing issue with the GUI mode. When I access the GUI mode; the debug says authentication failed.
Try entering the enable secret for the password without entering anything for the username. You might just be configured to use local authentication rather than ACS. Default enable secret is "Cisco", note the capital C.
If that works, check your telnet (vty) configuration. If you need assistance with that, post your config and someone would likely be able to pinpoint the problem.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...