Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AIR-702W - Configure Local LAN ports from WLC 5760

hello,

was hoping someone might be able to assist with the following:  i am trying to configure local LAN ports on my 702w AP's for access mode and vlan from AIR-5760 CLI.  can find good examples of how to do this in Air-OS, but not in IOS-XE.  i managed to get the LAN ports enabled as follows, but cannot work out how to configure mode/vlans - "shutdown" appears to be the only command/syntax option available:

 wc5760-02#ap name AP0008.2f1c.0628 no lan port-id 1 shutdown 


wc5760-02#sho ap name AP0008.2f1c.0628 lan port summ
LAN Port status for AP AP0008.2f1c.0628
Port ID  Status
-----------------
LAN1     Enabled
LAN2     Disabled
LAN3     Disabled
LAN4     Disabled

wc5760-02#ap name AP0008.2f1c.0628 lan port 1 ?
  shutdown  Disable the Port

 

does anyone know how to configure local LAN ports from here in IOS-XE?  my AIR-CT5760 SW ver = 03.06.00E;  my 702w SW ver =  10.2.102.0

 

thank you for your assistance...

 

gt

  

3 REPLIES

Configuring VLANs on AP

Configuring VLANs on AP 702W

From code release 8.0.75.1 onward, you can configure LAN ports and VLAN assignments.

Before setting VLANs, enable the LED state on the 702W AP, so you can confirm whether the client is connected because the ports and LEDs are in disabled state by default.

To enable the LED state from the CLI, use the command: config ap led-state enable

New Member

 i believe code release

 

i believe code release mentioned above refers to Airespace Operating System?  we have 5760's running IOS-XE.  while i am able to find configuration examples of 702w VLAN tagging on platforms running Airespace OS, i can find nothing re: 702w local LAN VLAN tagging configuration from IOS-XE 03.06.00E. 

VIP Purple

Hi I do not think IOS-XE 3.6

Hi 

I do not think IOS-XE 3.6 supports vlan tagging of this 702W AP model. May be in upcoming releases they may support this.

 

HTH

Rasika

***Pls rate all useful responses ****

543
Views
15
Helpful
3
Replies
CreatePlease to create content