Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AIR-ANT2506 problem

i have AIR-ANT2506 installed on ap's for outside and it seems as though i am loosing signal strentgh on them when i investigate the ant is filling up with water due to the lip that is on them. is there a model better suited for my needs.

5 REPLIES
Bronze

Re: AIR-ANT2506 problem

jeremy

a quick question were the antennas mounted with the cable at the bottom ( the antenna mounted vertically) or out the top (antenna mounted Inverted)

Bill

New Member

Re: AIR-ANT2506 problem

inverted

Bronze

Re: AIR-ANT2506 problem

that is probably why they collected water, antennas are designed to be installed with the cable exiting the bottom. there is no drain hole when they are mounted inverted.

when used indoors you would mount them inverted but outdoors right side up.

Bill

New Member

Re: AIR-ANT2506 problem

is there a similar model antenna that is water sealed or do i need to have sealant put around the cable.

Bronze

Re: AIR-ANT2506 problem

as far as i know all outdoor antennas have a weep hole to allow condensation to drain.

Bill

160
Views
0
Helpful
5
Replies
CreatePlease login to create content